| === xfaf is now known as zul | ||
| === dendro-afk is now known as dendrobates | ||
| === dendrobates is now known as dendro-afk | ||
| HugoKuo | is there have ubuntu hardy image for eucalyptus ? | 06:54 |
|---|---|---|
| === dendro-afk is now known as dendrobates | ||
| elro | Is it possible to configure a virtual machine to use a physical disk? | 15:29 |
| === dendrobates is now known as dendro-afk | ||
| === dendro-afk is now known as dendrobates | ||
| === dendrobates is now known as dendro-afk | ||
| === dendro-afk is now known as dendrobates | ||
| elasticdog | does UEC not use the front-end machine's /etc/eucalyptus/eucalyptus.conf file to configure the available IP address pool? | 16:22 |
| elasticdog | http://pastie.org/1342671 is what I put in there (and the VNET_DNS), but even with restarting everything, available IPs don't seem to change | 16:23 |
| elasticdog | someone else set up the machines originally, and put in 192.168.1.100-192.168.1.199 during the installation procedure, but I can't find that range referenced anywhere | 16:25 |
| elasticdog | nobody has experience changing the address pool with UEC post-installation? | 18:25 |
| kim0 | elasticdog: I'm not at all sure | 19:05 |
| kim0 | elasticdog: BUT you may need to do this | 19:05 |
| kim0 | sudo stop eucalyptus CLEAN=1 | 19:05 |
| kim0 | the CLEAN=1 flushes cached network info AFAIK .. which may be what you're looking for | 19:06 |
| kim0 | sudo service eucalyptus-nc stop CLEAN=1 | 19:07 |
| kim0 | too and perhaps use them when starting too | 19:07 |
| elasticdog | yep, I've done the clean restarts and tried rebooting all of the machines as well, with no luck | 19:49 |
| TritoLux | Hello there, I have a freshly installed UEC 10.10 cloud based on MANAGED-NOVLAN config and I am having a problem with EBS: if I use iSCSI then everything seems to work fine, but if I reboot the CC-SC machine, then the existing volumes cannot be attached anymore. If I use AoE, then it's even worse, as the new volumes I create can be attached, but they do not even appear within the instance, regardless of VIRTIO_DISK setting. I follo | 22:51 |
| TritoLux | wed official instructions step by step and I am only using images from the store. Any help would be greatly appreciated. Thank you in advance. | 22:51 |
| TritoLux | Another weird issue I am having is that if I run the image 10.04 64 bits, installed from the Store, then it never comes up properly the first time. I always have to reboot it after launching it in order to gain access to it. | 23:36 |
| TritoLux | Did anybody else experience above problems already? Are they known issues? | 23:36 |
Generated by irclog2html.py 2.7 by Marius Gedminas - find it at mg.pov.lt!