=== xfaf is now known as zul === dendro-afk is now known as dendrobates === dendrobates is now known as dendro-afk [06:54] is there have ubuntu hardy image for eucalyptus ? === dendro-afk is now known as dendrobates [15:29] Is it possible to configure a virtual machine to use a physical disk? === dendrobates is now known as dendro-afk === dendro-afk is now known as dendrobates === dendrobates is now known as dendro-afk === dendro-afk is now known as dendrobates [16:22] does UEC not use the front-end machine's /etc/eucalyptus/eucalyptus.conf file to configure the available IP address pool? [16:23] http://pastie.org/1342671 is what I put in there (and the VNET_DNS), but even with restarting everything, available IPs don't seem to change [16:25] someone else set up the machines originally, and put in 192.168.1.100-192.168.1.199 during the installation procedure, but I can't find that range referenced anywhere [18:25] nobody has experience changing the address pool with UEC post-installation? [19:05] elasticdog: I'm not at all sure [19:05] elasticdog: BUT you may need to do this [19:05] sudo stop eucalyptus CLEAN=1 [19:06] the CLEAN=1 flushes cached network info AFAIK .. which may be what you're looking for [19:07] sudo service eucalyptus-nc stop CLEAN=1 [19:07] too and perhaps use them when starting too [19:49] yep, I've done the clean restarts and tried rebooting all of the machines as well, with no luck [22:51] Hello there, I have a freshly installed UEC 10.10 cloud based on MANAGED-NOVLAN config and I am having a problem with EBS: if I use iSCSI then everything seems to work fine, but if I reboot the CC-SC machine, then the existing volumes cannot be attached anymore. If I use AoE, then it's even worse, as the new volumes I create can be attached, but they do not even appear within the instance, regardless of VIRTIO_DISK setting. I follo [22:51] wed official instructions step by step and I am only using images from the store. Any help would be greatly appreciated. Thank you in advance. [23:36] Another weird issue I am having is that if I run the image 10.04 64 bits, installed from the Store, then it never comes up properly the first time. I always have to reboot it after launching it in order to gain access to it. [23:36] Did anybody else experience above problems already? Are they known issues?