| === chihchun_afk is now known as chihchun | ||
| === chihchun is now known as chihchun_afk | ||
| === bromide is now known as discopig | ||
| snkt | hello | 06:02 |
|---|---|---|
| === chihchun_afk is now known as chihchun | ||
| IamTrying | http://beagleboard.org/Products/BeagleBoard-xM - I have tihs board. How can i install Ubuntu 13.10 kernel 3.11 on it? | 07:00 |
| infinity | IamTrying: http://ports.ubuntu.com/ubuntu-ports/dists/saucy/main/installer-armhf/current/images/omap/netboot/boot.img-fb.gz | 07:08 |
| infinity | IamTrying: Write that to an SD card, boot, and install. | 07:08 |
| infinity | IamTrying: (Ideally, install to external media, like a USB hard drive) | 07:09 |
| IamTrying | infinity, Can i just make the boot.img.fb.gz int my USB stick? and install it via USB ? | 07:10 |
| infinity | IamTrying: Been a while since I played with one, but unless it has a burned in SPI that lets you slect a boot device, it almost certainly only boots from SD. | 07:11 |
| infinity | IamTrying: So, you'll need an SD card both for the installer, and for the kernel/bootloader to live on in the final setup (same card, of course, the installer will reformat it). | 07:11 |
| IamTrying | infinity, I have less trust in Flash card u know. They fail for long run. So was thinking to use USB Stick with higher speed. | 07:12 |
| IamTrying | infinity, SD card i wanted to avoid if possible | 07:12 |
| infinity | IamTrying: No, no. You only have to BOOT from the SD card. Like I said, you should INSTALL the system to an external USB device. | 07:12 |
| IamTrying | OK - infinity | 07:13 |
| infinity | IamTrying: The SD isn't likely to fail if you never write anything to it other than a bootloader and kernel once in a while. | 07:13 |
| infinity | (Which will all happen automatically) | 07:13 |
| IamTrying | OK - infinity, so i have one 16GB SD card and one 120GB USB Disk. Now i write the boot.img-fb.gz in my 16GB SD card? And then while install i choose 120GB USB stick right? | 07:14 |
| infinity | IamTrying: Right. | 07:16 |
| IamTrying | OK - Excellent, thank you so much infinity, will let you know after installation, have a nice day. | 07:16 |
| infinity | IamTrying: Also, that -fb image is if you have a monitor and keyboard attached. If you're doing it via a serial console, you want this instead: | 07:17 |
| infinity | http://ports.ubuntu.com/ubuntu-ports/dists/saucy/main/installer-armhf/current/images/omap/netboot/boot.img-serial.gz | 07:17 |
| === doko_ is now known as doko | ||
| === chihchun is now known as chihchun_afk | ||
| === Darkwing_ is now known as Darkwing | ||
| === Tassadar_ is now known as Tassadar | ||
| === plars is now known as plars-afk | ||
Generated by irclog2html.py 2.7 by Marius Gedminas - find it at mg.pov.lt!